disks partition 6GB Linux N P 6063 B T 83 B hdc1
128MB Swap N P 125 T 82 hdc2 W Q
swap /dev/hdc2 scan
linux /dev/hdc1 scan
root mount /dev/hdc1
kernel from /dev/fd0 Rescue Disk Drivers Disk
devices misc psaux
network host = debian
connected = no
base from /dev/fd0 Base Disks 1-7
config timezone Australia ACT GMT no
(skip the "Make Linux boot directly from hard disk")
Make boot floppy Custom Boot
With the initial boot the extra internal bay hard disk drive had to be
mentioned to the kernel with the following command line when the boot
prompt is displayed (you have about 10 seconds to begin typing):
boot: linux hdc=13424,15,63
(the numbers were eventually figured out one time when the drive was
eventually auto-detected after a kernel upgrade).
Copyright © 1995-2019 Togaware Pty Ltd
Support further development through the purchase of the PDF version of the book.
Brought to you by Togaware and the author of open
source software including Rattle and wajig.
Also the author of Data Mining with Rattle and Essentials
of Data Science.